H-Bond Protector is an innovative product that acts in the protection and restoration of hair fiber. Protein serum acts within the hair's cortical matrix to the outer layers, protecting and increasing the strength of the hair fiber by up to 40% during chemical processes, especially those with oxidative action. The protein whey and the Potentiator have bio-affinity with the wires and do not interfere with the results and time of action of the chemical processes, reducing the aggressions and damages to the hair fiber.***Packaging May Vary
ATTENTION! Follow the instructions, precautions and warnings for using the bleaching and oxidizing powder correctly. The use of H-BOND PROTECTOR it does not replace the need for precautions, sensitivity testing or wick testing, which is commonly performed before chemical processes.
Protector P1 = pH 2,5 - 3,5
P2 Enhancer = pH 3,5 - 4,5
INDICATION OF USE:
- All types of hair.
- Must be used in the process of discoloration, coloring and transformation Honma Tokyo.
H-Bond Plex Protector and Enhancer Kit
The H-Bond Protector line it is designed to protect hair, but if not used in sufficient quantity, it will not have the desired effect. Find out how much of the product you should use to keep hair looking healthy.
HOW TO USE ONE:
H-Bond Protector (P1) next to the Bleaching Powder:
1. Use the standard measure of 30g bleaching powder + 60 ml of hydrogen peroxide + 7,50ml (full meter) of Protector (P1).
Mix well and start the bleaching process according to the chosen technique.
After the discoloration process, rinse hair and scalp thoroughly. Do not use shampoo. Remove excess water with a towel.
To complete the procedure, use the H-Bond Protector Enhancer (P2), evenly distributed over the entire length of the wires. Leave on for 10 to 20 minutes.
Rinse well. Wash and condition with shampoo and conditioner Honma Tokyo of your preference.
HOW TO USE 2:
Spraying H-Bond Protector (P1)
Divide the hair into 4 parts and apply 2 to 3 sprays wick to lock of the H-Bond Protector (P1) from the middle to the ends.
Align the strands with a fine comb and wait 10 minutes.
After the pause time, without rinsing the hair, start the bleaching process according to the chosen technique.
After the discoloration process, rinse hair and scalp thoroughly. Do not use shampoo. Remove excess water with a towel.
To complete the procedure, use the H-Bond Protector Enhancer (P2), evenly distributed over the entire length of the wires. Leave on for 10 to 20 minutes.